Did you enable and set the encryption trigger for the recipient or for
the sender? The encryption trigger is a sender property, i.e., the
trigger should be enabled/set for the sender.
and what about the recipient?
Do I have to define a profile for each recipient and if yes, what are the settings for this profile?
I have tried different settings, but either the email wasn't encrypted at all or I received a message telling me that the email couldn't be encrypted and therefore wasn't send.
Are you sure it was either not encrypted or a "bounce" that the message
could not be encrypted? If encryption is forced with the subject
trigger, the message will only be "bounced" back to the sender if the
message cannot be encrypted. If you want to always encrypt the message
you either have to set a static password for all recipients, or select
"Send to originator" or setup the OTP password mode.
Kind regards,
Martijn Brinkers
ยทยทยท
On 01/-10/-28163 08:59 PM, Stefan Michael Guenther wrote:
Did you enable and set the encryption trigger for the recipient or for
the sender? The encryption trigger is a sender property, i.e., the
trigger should be enabled/set for the sender.
and what about the recipient?
Do I have to define a profile for each recipient and if yes, what are the settings for this profile?
I have tried different settings, but either the email wasn't encrypted at all or I received a message telling me that the email couldn't be encrypted and therefore wasn't send.